Matte Gold Rhinestone Slider Bracelet Component Set for 2mm Round Leather


In StockIn StockOut of stock
Shipping calculated at checkout.

Matte gold rhinestone slider bracelet component set for 2mm round leather. Use this 4 piece set to create a stunning bracelet. Sets include 1 large rhinestone slider, 2 small sliders and a magnetic clasp.

Leather NOT included. Pick from our wide variety of colors in 2mm round leather.

To make a bracelet like the one pictured you will need the following:

  • Approximately 50 inches of 2mm leather
  • Loctite Glue Z007890
  • Sharp leather scissors TL00065
  • A toothpick - this helps to get the glue into the clasp. 

** For the silver version of this rhinestone slider set, see A020663

Directions are as follows:

  1.  Cut 5 pieces of leather at 10 inches long each.
  2. Add a small amount of glue into one side of the clasp.
  3. Take all 5 pieces of leather and tuck one end into the clasp. Make sure to not overlap the leather pieces. Hold in place to ensure it is secure.
  4. Slide one of the small slides onto the top 2 pieces of leather.
  5. Slide the 3 middle pieces of leather through the large slide. 
  6. Slide the bottom 2 pieces of leather through the last small slide.
  7. Determine your desired length for your bracelet and trim the leather. Make sure to account for the clasp in your measurement.
  8. Add a small amount of glue to the other side of the clasp.
  9. Repeat step 3.
  10. Let dry for an hour and then you can arrange the slides as desired.  

Sold as: 1 Set

Out of stock

SKU: A020664N/A
Not enough items available. Only [max] left.
Browse WishlistRemove Wishlist